VALVE-INLET 4P2854 - Caterpillar

Note: Your machine may not be equipped with all of the following controls.
Illustration 1 g01147692
Electronic Modular Control Panel II+ (EMCP II+)
(1) Generator set control + (GSC+)
(2) Engine control switch (ECS)
(3) Panel lights (PL)
(4) Alarm module (ALM)
(5) Synchronizing lights module or Custom alarm module (CAM)
(6) Speed potentiometer (SP) or Governor switch
(7) Voltage adjust rheostat (VAR)
(8) Emergency stop push button (ESPB)
(9) Panel light switch (PLS) The Electronic Modular Control Panel II+ (EMCP II+) is located above the generator distribution housing. The control panel consists of the following components: a main panel with indicators, meters and control switches. This control panel may be equipped with optional modules in order to match the customers' needs and requirements.The left side of the control panel contains the Generator Set Control + (GSC+). This is the main component of the system. The GSC+ displays the following information: generator output, fault conditions and key engine parameters. The center section of the control panel contains switches and an optional alarm module. The right side of the control panel may be blank, or the right side of the control panel may contain the Synchronizing Lights Module or the Custom Alarm Module. Some components are optional. The optional components may not be required for your particular application. Generator Set Control + (1) - The generator set control + (GSC+) is the main component of the EMCP II+. See the topic "Generator Set Control + (GSC+)" in this section.Engine Control Switch (2) - The engine control switch (ECS) determines the status of the control panel. In the AUTOMATIC position, the engine will start automatically when a remote initiated contact is closed. The engine will be shutdown after the contact opens. The engine will be shutdown after a cooldown period that is programmable has elapsed. The cooldown period can be programmed to give a 0 to 30 minute cooldown period before the engine shuts down.In the MANUAL START position, the engine will start. In the MANUAL START position, the engine will run when ECS remains in the MANUAL START position.In the STOP position, the engine is shutdown by the fuel solenoid after a programmable cool down time period has elapsed.In the OFF/RESET position (12 o'clock), the fault lights are reset and the engine shuts down immediately.
The engine must be cranking before using the start aid switch. Damage to the engine is possible if ether is released to the engine but not exhausted or burned by the engine when cranking.
Panel Lights (3) - Panel lights (PL) are controlled by panel lights switch (9). The panel lights switch is an ON/OFF switch.Alarm Module (4) - The alarm module (ALM) is optional. The ALM provides a visual warning. The ALM provides an audible warning of engine conditions before these conditions become severe. Engine conditions that are severe may cause the engine to shutdown. Engine conditions that are severe may cause the engine not to start.Synchronizing Lights Module (5) or Custom Alarm Module (5) - The synchronizing lights module uses synchronizing lights for paralleling the