VALVE 5309383 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes.
Open the engine enclosure.
Turn the battery disconnect switch to the OFF position.
Drain the hydraulic oil from the hydraulic oil tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
Illustration 1 g03458256
Remove the nut and disconnect cable assemblies (1) from the electric starting motor.
Illustration 2 g03458260
Remove bolts (3) and (4) from vibratory valve (2).
Move hoses (5) out of the way.
Illustration 3 g03458262
Disconnect harness assemblies (6) from vibratory valve (2).
Disconnect four hose assemblies (7) from vibratory valve (2).
Illustration 4 g03458263
Disconnect hose assemblies (8) from vibratory valve (2).
Remove two bolts (9) and vibratory valve (2). Installation Procedure
Install vibratory valve (2) in the reverse order of removal.