VALVE GP- 5363841 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-8440 Component Cleaner 1
B 4C-9500 Quick Cure Primer 1
C 1U-8846 Gasket Sealant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01151892
Clean the joint face on front housing (4) with Tooling (A).
Apply Tooling (B) to the joint face. Note: Do not allow Tooling (C) to seal the main oil passage on front housing (4).
Apply Tooling (C) to the joint face. Spread the sealant uniformly. Front housing (4) must be installed within ten minutes of applying the sealant.
Position front housing (4) on the cylinder block.
Install bolts (3).
Install bolts (5).
Illustration 2 g01151885
Connect harness assemblies (1) and (2). End By:
Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
Install the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
Install the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Install".