VALVE GP-PILOT 5430267 - Caterpillar

Removal Procedure
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Close the jaws of the work tool and ensure that the work tool is resting on a hard, level surface. Position the work tool on a side. Shut the engine off on the host machine. Relieve the pressure in the hydraulic system. Refer to the service manual for the host machine for the proper procedure. Close the ball valves on the stick of the host machine.
Put identification marks on all hoses for installation purposes. Plug all hoses in order to help prevent fluid loss and contamination of the fluid system.
Illustration 1 g00711455
The speed control valve has been removed for photographic clarity.
Open two screw plugs (1) on speed control valve (2) in order to relieve the system of any additional pressure.
Illustration 2 g00711450
Remove four bolts (3) and the washers that secure speed control valve (2) to the hydraulic cylinder. Remove the valve from the cylinder.
Illustration 3 g00710512
Remove three O-ring seals (4) from valve (2) .