VALVE GP-CONTROL 5577579 - Caterpillar

Introduction
A new aftercooler core is available for 3406E, C15, and C18 marine engines. The part number of the core is 315-0047 Aftercooler Core As . This part number is the latest update in a series of updates to the core.Upgrading the core on most engines involves switching the aftercooler core only. Early 3406E serial numbers with the 118-8629 Core will need new parts in order to perform an upgrade to the latest core.Required Parts
Table 1
Qty     New P/N     Description     Old P/N     Reason    
1     315-0047     Aftercooler Core As     118-8629     Latest Core    
1     251-9228     Aftercooler Cover     123-0416     The new cover accommodates different cores and adapters.    
2     144-3288     Adapter     123-8183     New adapters prevent raw water from leaking into the engine.
   
2     3P-0654     O-Ring Seal     3P-0657     The O-ring creates a seal between the adapter and the aftercooler cover.    
2     3P-0657     O-Ring Seal     6V-5656     The O-ring creates a seal between the adapter and the aftercooler core.    
2     201-4233     Gasket     123-5205     The gasket seals the aftercooler housing.    Recommended Parts
Table 2
Qty     New P/N     Description     Old P/N     Reason    
2     0L-1352     Bolt     0S-1619     The new bolt creates deeper thread engagement between the head and the aftercooler base.    
4     3H-5844     Bolt     3B-1915     The new bolt is now made of stainless steel. The previous bolt was coated with zinc.    
4     110-8314     Hard Washer     5M-2894     The new washer is now stainless steel. The previous washer was coated with zinc.    
1     218-3840     Pressure Sensor Gp     111-2350     The boost sensor has a brass pressure port instead of a steel pressure port.    
Illustration 1 g01683373
New Parts (1) Pressure Sensor (2) Bolt (3) Cover (4) O-ring (5) Bolt (6) Washer (7) Adapter (8) Gasket (9) Core (10) O-RingNote: Refer to Disassembly and Assembly, SENR1169 for the removal and the installation procedure for the aftercooler.. When the aftercooler is updated, also ensure that the correct condensate drain lines are installed on the aftercooler housing. Use the 134-3458 Aftercooler Drain Lines Gp when the rear of the engine is lower than the front of the engine. Use the 134-3459 Aftercooler Drain Lines Gp when the front of the engine is lower than the rear of the engine.Note: It is not necessary to replace the aftercooler base with the latest part number. If the aftercooler base is updated, then the aftercooler condensate drain group must also be updated. The latest part number of the drain group is 224-2382 Aftercooler Drain Lines Gp .Serial number effectivity is (S/N: 9WR1-916).