VALVE GP-CONTROL 6E3031 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5B-4274     Bolt     3    
B     8T-0914 (1)     Guide Pin     2    
( 1 ) Part of 9U-5105 Engine Tool Group Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel and Ring Gear - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Illustration 1 g01294474
Note: It is not necessary to remove adapter (4) in order to remove the crankshaft rear seal.
Remove bolts (2) that hold the crankshaft rear seal and adapter (1) in place.
Install Tooling (A) in adapter (1). Tighten Tooling (A) evenly. Remove the crankshaft rear seal and adapter (1) from the flywheel housing.
Install Tooling (B) through the holes in adapter (4) .
Remove bolts (3) that hold adapter (4) in place.
Slide adapter (4) onto Tooling (B). Attach a suitable lifting device to adapter (4). The weight of adapter (4) is approximately 65 kg (143 lb). Remove adapter (4) from Tooling (B) .