VALVE GP-PRESS & FLOW CMPNSTR 6E6170 - Caterpillar

Remove Flywheel Housing
START BY:a. remove oil panb. remove flywheelc. remove rear seal 1. Remove bolts (2). Move bracket (1) for the fuel filter to one side. 2. Remove turbocharger drain line (6).3. Remove four bolts (7), two bolts (4) (found on the rear of the flywheel housing) and four nuts (5). Remove bracket (3). 4. Fasten tooling (A) and a hoist to the flywheel housing.5. Remove bolts (10) and bolts (11).6. Remove bolts (9). Remove plate (8). Remove one bolt found behind plate (8).7. Remove the flywheel housing. Weight of the housing is 36.3 kg (80 lb.).Install Flywheel Housing
1. Install a new gasket on the cylinder block.2. Put the flywheel housing in position on the rear of the engine with tooling (A). Put 9S3263 Thread Lock on the bolts that hold the flywheel housing to the cylinder block.3. Install the bolt in location (1). Install the remainder of the bolts that hold the flywheel housing to the cylinder block. Cut the flywheel housing gasket even with the bottom of the cylinder block. 4. Install plate (5). Put bracket (3) in position on the flywheel housing. Install four bolts (4) and two bolts (2).5. Put 5P3931 Anti-Seize Compound on studs (6). Install the nuts on studs (6), and tighten them to a torque of 25 4 N m (20 3 lb.ft.). 6. Install turbocharger drain line (8). Put 5P3931 Anti-Seize Compound on bolts (7) which hold line (8) to the turbocharger.7. Install the bracket for the fuel filter on the side of the flywheel housing.END BY:a. install rear sealb. install flywheelc. install oil pan