VALVE GP-RELIEF 6E6285 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7575     Link Bracket     1    
B     138-7574     Link Bracket     1    
C     8C-0537     Bolt     1    
D     1U-6436     Duo-Cone Seal Installer As     1    
Illustration 1 g01133685
Raise the temperature of bearing cone (8). Install bearing cone (8) .
Illustration 2 g01133684
Attach a suitable lifting device onto brake carrier (6). The weight of brake carrier (6) is approximately 41 kg (90 lb). Position brake carrier (6) and install Tooling (C). Install bolts (7). Tighten bolts (7) to a torque of 200 N m (148 lb ft).
Illustration 3 g01133683
Remove Tooling (C) .
Illustration 4 g01133680
Install bolts (5). Tighten bolts (5) to a torque of 200 N m (148 lb ft).
Illustration 5 g01133677
Use Tooling (D) and install Duo-Cone seal (4) .
Illustration 6 g01133675
Lower the temperature of bearing cups (3). Install bearing cups (3) into wheel hub (1). Use Tooling (D) and install Duo-Cone seal (2). Attach Tooling (A) to wheel hub (1) .
Illustration 7 g01133674
Attach Tooling (A) and a suitable lifting device onto wheel hub (1). The weight of wheel hub (1) is approximately 34 kg (75 lb). Install wheel hub (1). Install Tooling (B) and a chain, as shown. Remove Tooling (A) .End By: Install the final drive. Refer to Disassembly and Assembly, "Final Drive - Install".