VALVE GP-CONTROL 6E6287 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-3145 Load Leveling Beam 1
B 189-0409 Shackle As 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01721578
Illustration 2 g01717139
Attach Tooling (B) onto Tooling (A). Attach Tooling (A) and a suitable lifting device onto generator (14). The weight of generator (14) is approximately 625 kg (1378 lb). Note: Ensure the correct center of gravity of the generator.
Use Tooling (A) to position generator (14). Align studs on the flywheel housing with generator (14). Align the studs on flywheel (22) with generator drive plate (21). Note: If necessary, rotate the crankshaft in order to align studs with the generator drive plate. Do not rotate the generator drive plate in order to align the drive plate with studs.
Install washers to the studs and loosely install new locking nuts (19) to the flywheel housing of generator (14). Loosely install bolts and washers (23) to the flywheel housing of generator (14). The generator should be correctly mounted onto the flywheel housing. Tighten bolts to a torque of 44 N m (33 lb ft). Tighten locking nuts to a torque of 44 N m (33 lb ft).
Install washers and loosely install new locking nuts (20) to the studs of drive plate (21) of generator (14). Rotate the crankshaft by one full revolution, in order to align the drive plate for the generator with the flywheel. Note: Do not rotate the generator drive plate in order to align the generator drive plate with the flywheel.
Tighten locking nuts (20) to a torque of 44 N m (33 lb ft).
Illustration 3 g01717146
Illustration 4 g01721613
Position screen (18) onto generator (14). Install bolts (17) to the screen. Tighten bolts securely.
Use Tooling (A) to raise the engine and generator (14) sufficiently in order to allow removal of wooden blocks. Lower the engine and the generator onto mounting.
Illustration 5 g01718575
The mounting on engines that are sea water cooled and keel cooled should be aligned with the mounting feet on the base for the generator. Install bolts (15) and tighten to a torque of 190 N m (140 lb ft). The mounting for engines that are for the radiator cooled engines. The generator should be aligned with the mounting feet on the base for the generator. Install nuts and bolts (15). Tighten nuts and bolts for the generator and the front engine mountings to a torque of 190 N m (140 lb ft).
Remove Tooling (A) from generator (14).
Install blanking device (12) and blanking device (13) to lifting eyes on generator (14).
Illustration 6 g01717420
Illustration 7 g01717134
If the engine is installed with the twin wall fuel injection lines install the alarm tank. Position alarm tank (8) onto bracket (10). Install bolts and nuts (11) and tighten bolts and nuts to a torque