VALVE GP-SOLENOID 7I0124 - Caterpillar

Illustration 88 g01545954
Raise the temperature of bearing cone (18) . Install bearing cone (18) . Install spacer (17) .
Illustration 89 g01545933
Illustration 90 g01546313
Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
Lower the temperature of bearing cups (13) and (15) . Use Tooling (C) in order to install bearing cups (13) and (15) into wheel flange (11) . Use Tooling (C) in order to install seal (16) into wheel flange (11) . Install seal (16) to the depth of Dimension (B) . Dimension (B) is equal to 4.0 mm (0.16 inch). Install O-ring seal (14) .
Illustration 91 g01545919
Install wheel flange (11) and bearing cone (12) .
Illustration 92 g01545913
Install ring gear hub (10) into ring gear (8) . Install retaining ring (9) .
Illustration 93 g01545874
Install ring gear (8) .
Illustration 94 g01545815
Use Tooling (A) in order to install spanner nut (5) . Tighten spanner nut (5) to a torque of 1000 50 N m (740 37 lb ft). Install locking plate (6) and new bolts (7) . Tighten bolts (7) to a torque of 70 4 N m (52 3 lb ft).
Illustration 95 g01545796
Install axle shaft (4) .
Illustration 96 g01545773
Use Tooling (B) in order to install retaining ring (2) into sleeve (3) . Install sleeve (3) . Install axle shaft (1) .
Install the final drive planetary.
Install the axle housing, the axle shaft, and the wheel flange onto the axle.Axle Housing, Axle Shaft, and Wheel Flange - Installation Procedure
Table 6
Required Tools    
Tool     Part Number     Part Description     Qty    
A     155-0695     Threadlocker Sealant     1    
B     069-4707     Sealant     1    
Illustration 97 g01073273
Apply Tooling (B) to the mounting surface of brake cylinder assembly (3) .Note: Align the location marks that were made during the removal procedure.
Attach a suitable lifting device onto axle housing, axle shaft, and wheel flange (2) . The weight of axle housing, axle shaft, and wheel flange (2) is approximately 147 kg (325 lb). Position axle housing, axle shaft, and wheel flange (2) onto brake cylinder assembly (3) .
Illustration 98 g01546794
Apply Tooling (A) on the threads of bolts (1) . Install bolts (1) . Tighten bolts (1) to a torque of 280 14 N m (210 10 lb ft).
Repeat Steps 2 and 3 for the other side.
Fill the axle with oil. Refer to Operation and Maintenance Manual, "Axle Oil (Rear) - Change" and Operation and Maintenance Manual, "Capacities (Refill)".
Install the axle onto the machine.