VALVE-EXHAUST 7N0573 - Caterpillar

Note: Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood. To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, whichever occurs first . Experience has shown that maintenance intervals are most accurately scheduled on the basis of fuel consumption.Before each consecutive interval is performed, all of the maintenance items from the previous interval must also be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Fuel System - Prime
Generator Set - Test
Rotating Rectifier - Test
Daily
Cooling System Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Generator Load - Check
Walk-Around Inspection
Every Week
Generator - Inspect
Every 100 Service Hours or 3 Months
Insulation - Test
Every 500 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
First 700 L (185 US gal) of Fuel or First 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Engine Valve Lash - Inspect/Adjust
Every 4450 L (1175 US gal) of Fuel or 250 Service Hours or 1 Year
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Fuel Transfer Pump Strainer - Clean
Heat Exchanger - Inspect
Hoses and Clamps - Inspect/Replace
Every 4700 L (1250 US gal) of Fuel or 400 Service Hours or 1 Year
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Every 36 000 L (9500 US gal) of Fuel or 2000 Service Hours or 1 Year
Alternator - Inspect
Water Pump - Inspect
Every 36 000 L (9500 US gal) of Fuel or 2000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Water Temperature Regulator - Replace
Engine Valve Lash - Inspect/Adjust
Fuel Injection Nozzles - Test/Exchange
Generator - Dry
Starting Motor - Inspect
Turbocharger - Inspect/Clean
Every 43 200 L (11 250 US gal) of Fuel or 3000 Service Hours or 2 Years
Cooling System Coolant Extender (ELC) - Add
Every 108 000 L (28 500 US gal) of Fuel or 6000 Service Hours
Cooling System Coolant (ELC) - Change
Every 7500 L (2000 US gal) of Fuel or 1000 Service Hours
Rotating Rectifier - Check
Every 180 000 L (47 500 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations