VALVE GP-PRESSURE CONTROL 8E4963 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-9352 Engine Stand 1 Start By:
Remove the engine. Refer to Disassembly and Assembly, "Engine - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Attach the engine to tooling (A).
Illustration 1 g01255563
Remove oil drain plug (6) and the O-ring seal.
Remove the bolts (not shown) that secure the engine oil pan to the flywheel housing.
Remove bolts (3), (4), (5), and (7) from engine oil pan (8). Remove nuts (9).
Remove engine oil pan (8) and remove gasket (1) from the cylinder block.
If necessary, remove nut (2), the seal, and the tube assembly from the engine oil pan. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1U-9352 Engine Stand 1
B - Guide Bolt
M8 X 1.25 by 70 mm 4
C 165-2601 Silicon Sealant 1
D 9S-3263 Thread Lock Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean all surfaces thoroughly. Inspect the condition of the gasket. Replace the gasket, if necessary.
Illustration 2 g00541498
When the gasket for the oil pan is removed, damage may occur to the existing seal in the groove of the bridge. If the seal is damaged, apply a sufficient amount of Tooling (C) in order to fill the groove. The groove must be completely filled.
Apply Tooling (C) to the joint between the cylinder block and the front housing.
Illustration 3 g01255617
Install Tooling (B) in the cylinder block in Hole (X).
Position gasket (1) and engine oil pan (8) in the correct position on the cylinder block. Install bolts (5) in order to secure engine oil pan (8) to the cylinder block. Tighten bolts (5) finger tight. Note: New bolts have sealant to the first 13 mm (0.5 inch) of the threads. In order to reuse the old bolts, clean the old sealant from the bolts and apply Tooling (D) to the bolts.
Install the bolts (not shown) that secure the engine oil pan to the flywheel housing.
Remove Tooling (B). Install bolts (3), (4), and (7).
Tighten bolts (3), (4), (5), and (7) to a torque of 22 N m (16 lb ft).
Install the O-ring seal and drain plug (5). Tighten drain plug (5) to a torque of 34 N m (25 lb ft).
If necessary, install the seal and the tube assembly in the engine oil pan. Tighten nut (2) to a torque of 18 N m (13 lb ft).
Remove the engine from tooling (A).