VALVE GP-SELECTOR & PRESS CONT 8E7904 - Caterpillar

Illustration 8 g01880648
Illustration 9 g01880629
When the calibration has completed successfully, then the display will show "CAL 100" for two seconds. Then the display will show "CALDONE" in order to represent that the calibration is complete. After the calibration has been completed, press the mode button in order to return to the "V Calib" screen.Aborting the Calibration
Once the automated portion of the calibration has started, the operator may stop the calibration by any one of the following methods:
Pressing any button on the display
Pressing the trigger on the right hand joystick
Rolling the thumb roller on the right hand joystick out of the NEUTRAL position (or pressing the buttons that could be used instead of the thumb roller)
Moving either joystick out of the NEUTRAL position.
Illustration 10 g01880649
When the operator presses any button on the display, the calibration will be aborted. When this happens, the display will show "CALStop".If the operator aborts the calibration using any other method, for example, violating one of the machine safety interlocks, the display will indicate an error code. The error code will be shown in the following format: "ERRXXXX". The "XXXX" represents a four-digit error code that can be used to determine the cause of the error by referencing the correct documentation.
Illustration 11 g01880629
After aborting the calibration, press any button in order to return to the start of the valve calibration procedure ("U Calib").Calibration Failure
Illustration 12 g01880650
In the event that any other condition occurs which causes the calibration to fail, for example, a lost beam or a solenoid that is faulty, the calibration will be aborted. The Display will show the error codes in the following format: "ERRXXXX". The "XXXX" represents a four-digit error code that can be used to determine the cause of the error by referencing the correct documentation. If there is more than one error, then one error code will be displayed for 5 seconds before displaying the next error code.
Illustration 13 g01880629
The operator may press any button while the error codes are displayed in order to return to the start of the calibration procedure for the valve ("U Calib").Valve Calibration Procedure
Preparation
Position the machine in an flat, open area away from personnel.
Warn personnel in the area that the work tool may move automatically.
Setup the laser transmitter on a tripod at least 4.6 m (15 ft) away from the receiver. Turn on the laser transmitter.
Attach the laser receiver to the mast. Connect the laser receiver to the machine with the coiled cable.
Position the blade so that it is approximately 2.54 cm (1.0 inch) above the ground.
Warm up the hydraulics on the machine to 45° C (113° F).
Use the AMICS display in order to navigate to the valve calibration screen.To continue to "Defining The Lower Limit", the following conditions must be met:
The parking brake must be enabled.
Engine speed must be at the top engine speed limit.
The implements must be enabled.If any of the conditions in the previous list are not met, then an error code will be displayed.Defining The Lower Limit
Press the "Down" button to begin defining the lower limit.If the