VALVE GP-SELECTOR 8I6026 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Lubricating Process (If Applicable)
Note: If the generator already has a visible grease point, go to Step 4.
Remove either the louver assembly or the rear plate from the rear of the generator housing.
Remove the top grease pipe plug and remove the lower grease pipe plug.
Install a grease fitting in the grease pipe.
Grease the bearings with 2S-3230 Bearing Lubricant.
Wipe off the excess grease. Remove the top grease fitting. Install the plug.
Operate the generator for 1 hour. This process will allow the grease to expand. The expanding grease will force the excess grease from the cavity. When the excess grease is forced from the cavity, the internal pressure will be reduced. The generator should continue to operate until the grease stops purging.
Stop the engine. Install the plug in the bottom grease pipe. Wipe off the excess grease.
Install the louver assembly or install the rear plate. Additional Information
Refer to Special Instruction, REHS4892, "Generator Bearing Service" for further information.