VALVE GP-SELECTOR & PRESS CONT 8P3041 - Caterpillar

1. Put wheel assembly (2) and bearings in position on spindle housing (1).2. Install outer bearing.3. Use an outside micrometer and measure the thickness of retainer (3) at the three small holes (A). Find the average thickness.4. Install retainer (3) without shims (5).5. Install three of bolts (4), so there are spaces between the bolts.6. Turn wheel assembly (2) slowly by hand, and tighten bolts (4) to a torque of ... 100 15 N m (75 11 lb.ft.)7. Loosen bolts (4) until retainer (3) is free. Tighten bolts (4) again to a torque of ... 55 7 N m (37 5 lb.ft.)8. Use a depth micrometer and measure through three small holes (A) in the retainer. Find the average depth.9. Find the difference between the two average measurements. The difference is the gap between the end of spindle housing (1) and retainer (3).10. Remove retainer (3). Install an amount of shims (5) the same thickness as the average gap found in Step 9 plus ... 0.23 mm (.009 in.)11. Install retainer (3) and all of bolts (4). Tighten bolts (4) evenly to a torque of ... 100 15 N m (75 11 lb.ft.)