VALVE ASSEM. 9B4510 - Caterpillar

Disassembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Personal injury can result from improper handling of chemicals.Make sure you use all the necessary protective equipment required to do the job.Make sure that you read and understand all directions and hazards described on the labels and material safety data sheet of any chemical that is used.Observe all safety precautions recommended by the chemical manufacturer for handling, storage, and disposal of chemicals.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the urea from the tank assembly.
Illustration 1 g06091087
Remove strainer assemblies (1) from the cabinet assembly
Illustration 2 g06091098
Remove bolts (2) and side door (3). Repeat for the other side.
Illustration 3 g06091111
Loosen clamp (5) and remove connector (4).
Illustration 4 g06091115
Remove bolts (6) and door assembly (7).
Illustration 5 g06091121
Remove bolts (8) and front door (9).
Illustration 6 g06091124
Disconnect harness assembly (10) and harness assembly (12) from electronic control group (11).
Illustration 7 g06091136
Remove bolts and studs (13), the mounts, the spacers, and electronic control group (11).
Illustration 8 g06091145
Disconnect the harness assembly for fluid level sensor assembly (14). Remove the machine screws and fluid level sensor assembly (14) from the tank assembly.
Illustration 9 g06091147
Disconnect hose (15) from the vent. Remove the vent from the tank assembly.
Illustration 10 g06091171
Disconnect the harness assemblies (17) from switch assembly (16). Remove nuts and disconnect the harness assemblies from switch assembly (16).
Illustration 11 g06091185
Remove the bolts (18) and switch assembly (16).
Illustration 12 g06091188
Remove hose assemblies (19), (20), and (21) .
Disconnect the tank heater assemblies from the main wiring harness.
Illustration 13 g06091214
Drain tank assembly (23) into a suitable container.
Remove strap assemblies (22). Remove tank assembly (23) from the control cabinet.
Illustration 14 g06092667
Remove tank cap (24) from tank assembly (23).
Illustration 15 g06092673
Remove cap adapter (25) from tank assembly (23).
Illustration 16 g06092677
Remove strainer (26) from tank assembly (23).
Illustration 17 g06091228
Disconnect harness assembly (27) from the temperature sensor. Disconnect harness assembly (28) from the heater group. Disconnect harness assembly (29) from the pressure sensor. Disconnect harness assembly (30) and harness assembly (31) from the solenoid valve groups.
Illustration 18 g06092602
Disconnect harness assembly (32) from the junction block. Disconnect harness assembly (33) from the pump heater. Disconnect harness assembly (34) and harness assembly (35) from the pump group.
Illustration 19 g06091234
Remove locknuts (36) and bars (37) from diesel exhaust fluid pump group (38).
Remove diesel exhaust fluid pump group (38) and manifold group (39) as an assembly.
Illustration 20 g06092518
Remove bolts (40). Disconnect diesel exhaust fluid pump group (38) from manifold group (39).
Illustration 21 g06091251
Remove solenoid valve group (41), solenoid valve group (43), and the O-ring