VALVE GP-BRAKE CONTROL 9N4677 - Caterpillar

Illustration 1 g01261192
(5) Gear (1) Torque for two studs ... 30 4 N m (22 3 lb ft) (2) Torque for four bolts ... 30 4 N m (22 3 lb ft)
Illustration 2 g01261196
(3) Torque for the regulator ... 17 2 N m (150 18 lb in) (4) Torque for three bolts that hold the retainer shaft ... 7.0 0.4 N m (60 4 lb in) (6) Torque for the bolt ... 100 5 N m (75 4 lb ft)
Illustration 3 g01261220
(A) Insert pin to the following depth. ... 5.0 1.0 mm (0.20 0.04 inch) (B) Orient the regulator to 10 5 degrees.
Illustration 4 g01261288
(7) Torque for the elbow ... 37 4 N m (27 3 lb ft) (C) Orient the elbow to 90 5 degrees. (8) Torque for the connector ... 22 2 N m (16 1 lb ft) (9) Torque for two bolts ... 30 4 N m (22 3 lb ft) (10) Torque for two nuts ... 30 4 N m (22 3 lb ft)
Illustration 5 g01261298
Use the following procedure after the pump has been installed to the housing:
Remove 267-2647 Stop Plug (11) and install 9S-4180 Plug (12) .
Torque the plug (12) to 4.5 0.5 N m (40 4 lb in).