VALVE-BAG & GAS 9T8819 - Caterpillar

Removal Procedure
Start By:
Remove the fuel tank. Refer to Disassembly and Assembly, "Fuel Tank - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Drain the cooling system coolant into a suitable container for storage or disposal. Refer to Operation and Maintenance, "Refill Capacities".
Illustration 1 g01178210
Disconnect hoses (1) and (2) .
Use two people to disconnect tube assemblies (3) and remove transmission oil cooler (4). The weight of transmission oil cooler (4) is approximately 45 kg (100 lb).