VANE KIT (REAR) 1206748 - Caterpillar

In order to avoid possible machine damage, back the machine onto the trailer.Ship the machine with the screed on blocks, and the tow arm cylinders fully retracted.Extendable screed must be parallel and inline before retracting.
Engage the parking brake.Stop the engine.Turn the start switch to the OFF position. Remove the start switch key.Turn the battery disconnect switch to the OFF position. Remove the disconnect switch key.Lock the access covers. Attach any vandalism protection.Chock the wheels. Secure the machine with tie-downs. Refer to Operation and Maintenance Manual, "Lifting and Tying Down the Machine" for instructions on tying down the machine.
Rotation of the turbocharger without engine operation can result in damage to the turbocharger.Cover the exhaust opening or secure the rain cap in order to prevent the turbocharger from windmilling in transit.
After the machine is on the trailer, lower the screed onto blocks that support the screed fully across the width of the screed. Install the vandalism cover on the operator panel.Cover the exhaust opening or secure the rain cap in order to prevent the turbocharger from windmilling in transit.To protect the cooling systems, mix the solution of antifreeze and water. The solution should provide protection to the lowest expected outside temperature. Drain the coolant into a suitable container.Perform a walk-around inspection and measure the fluid levels in the various compartments.Travel at a moderate speed. Observe all speed limitations when you are roading the machine.Exhaust Stack
In order to reduce the height of the machine for transport, lower the exhaust stack. Use the following procedure to lower the exhaust stack.
Illustration 2 g03330316
Remove retaining pin (1).
Pull down on the handle (2) in order to lower the exhaust stack. Note: If the exhaust stack is too loose, tighten bolt (3).
Illustration 3 g03330333
Remove pin (4).
Lower the exhaust.
Illustration 4 g03330336
Install pin (4) in order to keep the exhaust stack in the STORAGE position.
Illustration 5 g03330347
Lower plate (5) and install pin (1) in order to keep water and debris from entering the exhaust system. Note: Be sure to raise plate (5) before returning the exhaust stack to the upright position.
Reverse steps 1 through 6 in order to return the exhaust stack to the upright position. Foldable Canopy (If Equipped)
Lowering the Canopy
Illustration 6 g03330354
For each canopy support, rotate locking hub (1) down and pull in toward the center of the operator station.
Illustration 7 g03330357
Pull the canopy down using two handles (2).
Illustration 8 g03330360
When the canopy reaches the bottom position, catch (3) on each canopy support will engage the locking pin. Raising the Canopy
Pull down on handles (2) and release four locking catches (3).
Raise the canopy untilthe canopy is fully raised. Hydraulic Foldable Canopy (If Equipped)
In order to reduce the height of the machine for transport, lower the hydraulic foldable canopy (if equipped). Use the following procedure to lower the hydraulic foldable canopy.
Illustration 9 g03330438
Remove retaining pin (1) from the hydraulic canopy locking pin (2).
Remove the hydraulic canopy locking pin (2).
Illustration 10 g03330439
Move and hold down the hydraulic canopy switch (3) until the hydraulic canopy is fully lowered.