VENT AS-FUEL TANK 3552924 - Caterpillar

Recoil Spring Oil Compartment
Measure the Oil Level
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
1. Remove the oil fill cover plate. 2. Maintain the oil level to the level mark on the cylinder.3. Install the cover plate.4. Repeat the procedure on the other recoil compartment.Ripper Linkage and Cylinder Bearings
Lubricate the Fittings
Lubricate the twelve fittings.Tracks
Inspect Weekly
The pins and bushings in a dry joint can become very hot. It is possible to burn the fingers if there is more than brief contact with these components.
Follow these hints to extend the undercarriage life and to avoid excessive downtime.1. Listen for track squeak or squeal during machine operation. This can indicate a dry joint.2. Check for dry joints once a week, immediately after machine operation. After machine operation, lightly touch the end of each track pin or bushing, with the back of your hand. Make a mark on any joint that is very hot to the touch.Consult your Caterpillar dealer's Custom Track Service expert upon detection of dry joints or leaks and/or for track inspection.Cab Air Filter Elements
Clean the Filter Elements
Clean the filter elements daily when there is a reduction of air circulation. 1. Remove the covers.2. Remove and clean the filter elements. See "Cleaning the Filter Elements."3. Install the cleaned filter elements.4. Replace the covers and tighten the retainersIf the air conditioning does not cool after changing filters, check the wet-dry indicator. The indicator is on the left side of machine under the access cover for disconnect switch.Cleaning the Filter Elements
Pressure air can cause personal injury. When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Elements can be cleaned with pressure air or pressure water.1. Wash them in clean water and household detergent.2. Rinse thoroughly with clear water, and blow dry with pressure air.
Do not clean the elements by bumping or tapping them. Inspect the elements after cleaning. Do not use an element with damaged pleats, gaskets or seals.When cleaning with pressure water, use 280 kPa (40 psi) maximum pressure to prevent element damage.
3. Direct air or water along pleats inside and outside of the element.4. Air dry and inspect the element to see if any debris remains visible.