VISOR GP-PROTECTION 5I3313 - Caterpillar

Illustration 7 g01230596
(F) 103-2006 Screws
Reassemble the front cover of the right control panel to the rear cover. Secure the covers with six screws (F) .
Illustration 8 g01230951
(D) 258-3727 Screw (E) 258-4219 Plate
Locate the right control panel in position against header plate (E). Reinstall the four screws (D) in order to secure the panel to the plate.
Illustration 9 g01230520
(A) 214-2968 Flood Lamp Gp (B) 8T-4133 Nut (C) 8T-4121 Hard Washer
Reinstall right flood lamp (A) with nut (B) and hard washers (C) .
Then, plug the harness connector into the back of right flood lamp (A) .
Install rocker switch (1) by performing Step 1.a through Step 2.d.
Illustration 10 g01230958
(H) 109-2356 Plug (J) 258-4007 Switch Cover
Remove switch cover (J) from the 258-4004 Panel (RH). Use a thin blade screwdriver in order to release the locking tabs for the cover.Then, remove plug (H) by pushing out the plug from the back of the switch cover.
Illustration 11 g01231205
(1) 263-5420 Rocker Switch (J) 258-4007 Switch Cover
Insert rocker switch (1) into the switch cover (J). Push the rocker switch into the opening until the tabs lock the switch in position.
Locate harness connector L-C22 that is inside the 258-404 Panel (RH). See Table 2.Connect harness connector L-C22 to rocker switch (1).
Table 2
Harness Connector L-C22    
Pin     Description    
1     F764-L75 Green    
2     200-L141 Black    
3     F763-L74 White    
4     -    
5     -    
6     -    
7     200-L140 Black    
8     614-L137 Purple    
9     -    
10     -    
Reinstall switch cover (J) into the opening in the 258-404 Panel (RH). Push the switch cover into the opening until the tabs that are on both sides of the cover are locked in position.
Enable the display module and creeper control in the Cat Electronic Technician (ET) Service Tool.Note: Use the communication port inside the fuse panel in order to access the Cat Electronics Technician (ET) Service Tool.
Illustration 12 g01349705
With the engine stopped, switch the engine start switch ON. Then, open the Cat Electronics Technician (ET) Service Tool.
Illustration 13 g01349711
Select "Service" from the toolbar. Then, select "Machine Configuration" from the drop-down menu.
Illustration 14 g01349710
Change the "Gauge Cluster # 2 Installation Status" to "Installed". The display module and creeper control are now enabled.Turn the engine start switch OFF for at least 15 seconds. Then, turn the engine start switch ON.Appendix
The Display Module
Note: Be sure to flash the AMICS module with the most up-to-date software.
Illustration 15 g01232086
The 264-8861 Display Module Gp (AA) Hydraulic oil temperature gauge (BB) Digital display window (CC) Function selector (DD) "Scroll Down" key (EE) "Scroll Up" key (FF) Coolant temperature gauge