WASHER 0094089 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Do not attempt to assemble this machine until you read and you understand the assembly instructions.Improper assembly procedures could result in injury or death.
Note: Remove all protective shipping covers, flanges, plugs, caps, clamps, cable straps, and material.Note: Clean mounting and contact surfaces for major component installation free of wax, dirt, debris, paint, and grease.Note: If necessary, chase unprotected threaded holes with an appropriately sized tap to remove paint, rust, or other debris.Note: Unless otherwise specified, all torque requirements are Standard Torque values. Refer to the "General Information" section in this document for the correct torque values.Note: Before tightening the cable straps (mounting hardware), remove the slack from the harness assembly(s) and allow adequate strain relief.
Illustration 2 g06200996
(3) 490-5254 Plate As
(4) 135-8575 Bolt As
Install one plate assembly (3) and six bolt assemblies (4).
Illustration 3 g06201006
Illustration 4 g06201010
(1) 135-8577 Bolt As
(2) 458-2178 Strip
(7) 418-3652 Plate
(8) 458-2177 Mud Flap
Position mud flap (8). Install four plates (7), strip (2), and twelve bolt assemblies (1).
Illustration 5 g06201014
(5) 490-5255 Plate As
(4) 135-8575 Bolt As
Install plate assembly (5) and six bolt assemblies (4)
Illustration 6 g06201023
Illustration 7 g06201025
( 1) 135-8577 Bolt As
(2) 458-2178 Strip
(6) 273-8950 Plate
(9) 458-2176 Mud Flap
Position mud flap (9). Install three plates (6), strip (2), and twelve bolt assemblies (1).