WASHER 0389898 - Caterpillar

Illustration 1 g01135667
View of the 2Q-8537 Ride Control Gp Installation Procedure
Illustration 2 g01135612
Disposable Components of the 220-5571 Ride Control Gp (62) 201-1005 Tube As . (63) 197-7360 Spacer . (64) 176-3847 Accumulator Gp . (65) 167-0140 Bracket As . (66) 164-4058 Reducer Gp . (67) 231-7727 Tube As . (68) 231-7725 Hose As . (69) 198-6753 Hose As . (70) 174-9667 Bracket . (71) 231-7722 Clamp As . (72) 231-7724 Clamp As . (73) 6V-1874 Grommet . (74) 5P-7469 Clip . (75) 5P-7468 Clip . (76) 174-9670 Clamp As .
Illustration 3 g01135613
Reusable Components of the 220-5571 Ride Control Gp (77) 8T-4194 Bolt . (78) 8T-4196 Bolt . (79) 8T-4223 Hard Washer . (80) 8T-4224 Hard Washer . (81) 5P-7464 Clip . (82) 5P-7465 Clip . (83) 6V-1249 Grommet .
Remove the components that are shown in Illustration 2 and Illustration 3. Do not discard the components in Illustration 3. These pieces will be reused. Assemble the ride control accumulators, the brackets and the fittings as a subassembly before you install the components on the machine.
Illustration 4 g01135009
All dimensions are referenced to the edge of the block. The dimensions are not referenced to the centerline of the hole.All dimensions in millimeters (3) 178-0711 Plate . (14) 189-7804 Block . (38) 156-0052 Plate . (60) 9C-7929 Block .
Mount plate (38) inside the right tower plate. See Illustration 4 for reference. Weld the plate in place. Weld using standard welding procedures. Use low hydrogen electrodes or equivalent GMAW or FCAW processes. Welds should be of good quality and free of obvious defects.
Illustration 5 g01135010
All dimensions are referenced to the edge of the block. The dimensions are not referenced to the centerline of the hole.All dimensions in millimeters (3) 178-0711 Plate . (14) 189-7804 Block . (60) 9C-7929 Block .
Mount plate (3) in the location that is shown in Illustration 5. Weld the plate in place. Weld using standard welding procedures. Use low hydrogen electrodes or equivalent GMAW or FCAW processes. Welds should be of good quality and free of obvious defects.
Mount block (60) in the location that is shown in Illustration 5. Weld the block in place. Weld using standard welding procedures. Use low hydrogen electrodes or equivalent GMAW or FCAW processes. Welds should be of good quality and free of obvious defects.
Mount block (14) in the location that is shown in Illustration 5. Weld the block in place. Weld using standard welding procedures. Use low hydrogen electrodes or equivalent GMAW or FCAW processes. Welds should be of good quality and free of obvious defects.
Install the mounting brackets and the clamps on the accumulators. Hand tighten the nuts and the bolts.Note: Do not torque the nuts and bolts. This will be the last step in the subassembly.Note: In order to prevent leakage,