WASHER-SPRING 0828760 - Caterpillar

Illustration 1 g00939169
The automatic lubrication system is used to automatically lubricate the following components on the 24H Motor Grader:
Bearings for the lift cylinder trunnion (1)
Bearings for the lift cylinder yoke (2)
Bearings for the lift cylinder (3)
Top lean arm spindle bearings (4)
Bottom lean arm spindle bearings (5)
Bearings for the steering bar (6)
Bearings for the steering cylinders (7)
Bearings for the wheel lean cylinders (8)
Centershift cylinder bearings (9)
Lean bar bearings (10)
Axle lean bar bearings (11)
Blade lift cylinder bearings (12)
Bearings for the articulation cylinders (13)
Bearings for the upper articulation joint (14)
Bearings for the lower articulation joint (15)
Bearings for the ripper articulation joint (16)
Bearings for the ripper cylinder (17)
Illustration 2 g00939986
Front Frame (18) Right front axle injector bank (19) Left front axle injector bank (20) Lubricant pump group (21) Drawbar injector bank (22) Front frame articulation injector bank
Illustration 3 g00939979
Rear Frame (23) Ripper injector bank (24) Rear frame articulation injector bankThe Automatic Lubrication System consists of three systems. The three systems are the electrical system, the hydraulic system and the lubrication system. The electrical system turns the automatic lubrication system on and off at periodic intervals. The hydraulic system provides the power in order to pressurize the lubrication system. The lubrication system controls the flow of the lubricant to the bearings.