WASHER-THRUST 1197037 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: The axle is removed for photographic purposes.
Illustration 1 g00775801
Install the final drive (2) onto the front axle with two bolts (1). Tighten the bolts to a torque of 32 N m (24 lb ft).
Install a new O-ring seal onto the plug (3) .
Install the plug (3) into the final drive (2). Tighten the plug to a torque of 150 N m (110 lb ft).
Fill the final drive with oil. Refer to the following titles for more information: Operation and Maintenance Manual, "Refill Capacities", Operation and Maintenance Manual, "Lubricant Viscosities" and Operation and Maintenance Manual, "Final Drive Oil Level (Front) - Check".This information is found in the Operation and Maintenance Manual, SEBU7398 for the 416D Backhoe Loader.This information is found in the Operation and Maintenance Manual, SEBU7399 for the 420D and 430D Backhoe Loader.This information is found in the Operation and Maintenance Manual, SEBU7400 for the 424D, 428D, and 438D Backhoe Loader.This information is found in the Operation and Maintenance Manual, SEBU7401 for the 432D and 442D Backhoe Loader.End By: Install the front axle onto the machine. Refer to Disassembly and Assembly, "Drive and Steering Axle (Front) - Install".