WASHER 1406927 - Caterpillar

Machine Engines:
3176C (S/N: 3PD)
3196 (S/N: 5ED)
C-12 (S/N: JAC; CPN)
Disassembly and Assembly, SENR9537-03, "3176C and 3196 Engines For Caterpillar Built Machines", "Flywheel Housing - Remove and Install, Installation Procedure"Disassembly and Assembly, SENR9574-04, "C-10 and C-12 Industrial Engines", "Flywheel Housing - Remove and Install, Installation Procedure"Reference: A torque sequence for the bolts that mount the flywheel housing to the cylinder block has been added to the Installation Procedure for the flywheel housings on these machine engines. This change is shown in the text that follows. This change will be included in the next revision of these manuals.Installation Procedure
Illustration 1 g00514040
Apply 1U-6396 O-Ring Assembly Compound to O-ring seal (4). Install O-ring (4) .
Apply 1U-8846 Sealant (6) to the rear face of the cylinder block. Refer to Illustration 1.
Illustration 2 g00514036
Illustration 3 g00871860
Torque sequence
Make sure that dowels (3) are installed in the rear of the cylinder block. Position flywheel housing (2) on dowels (3) on the rear of the cylinder block. Install twelve bolts (1) and the washers. Use the torque sequence that is shown in Illustration 3 to tighten bolts (1) .End By:a. - Install the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install" .b. - Install the flywheel. Refer to Disassembly and Assembly, " Flywheel - Install".