WASHER 1K2636 - Caterpillar

1. Fasten a hoist to the steering clutches. Put the steering clutches in the correct position in the steering clutch case. Remove the hoist. Install the rod ends in the yokes.
Make sure the balls on the ends of the two yokes are in position in the sockets of the steering clutch case. Make sure the notch in each bearing cage is facing in an "UP" position.
2. Install new seals in the two caps as follows: a) Make sure the two caps are clean and dry. b) Put the seal in the groove of the cap at point (A). Work the seal around point (B) to point (C). Do not pull on the seal. Make sure the seal is in the groove by working the seal from point (C) back to point (A).c) Put a light amount of liquid soap on the wall in the steering clutch case where the seals make contact. Do not let the liquid soap get in the groove of the caps. 3. Put the bevel gear into position in relation to the bevel pinion to prevent damage to seal (2).4. Put the two caps (1) in position in the steering clutch case. Do not cause damage to the seals in the caps.
Make sure dowels in the caps are in the notches of the bearing cages before tightening down bolts.
5. Install the bolts and washers that hold the caps in position. If the seal is .25 in. (5.3 mm) above the top surface of the cap, the seal installation must be done again. After final installation trim the ends of the seal at points (A) and (C) to .06 in. (1.5 mm).6. Make an adjustment to the bevel gear bearing preload. See BEVEL GEAR AND PINION SETTINGS.7. Make adjustments to the gear tooth contact setting and gear clearance (backlash). See BEVEL GEAR AND PINION SETTINGS. 8. Install the bolts (5) and washers that hold the flanges to the drums of the steering clutches.9. Install the lock (3) and deflector (4).10. Install the gasket and cover over the bevel gear.11. Fill the bevel gear case with oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.end by: a) install steering clutch controlsDisassemble Steering Clutches
start by: a) remove steering clutches 1. Remove two bolts (1), washers and lock (2). 2. Install two 1/2"-13 NC bolts (3) in the drum as shown. Put tool (A) on the nut. Install a bar on the two bolts (3) as shown. Loosen the nut. Remove tool (A). Do not take the nut off the bevel gear shaft. Put the nut in position on the bevel gear shaft so there is a distance of .25 in. (6.53 mm) between the nut and the face of the drum. Remove the brake bands and linings. Remove the drum. 3. Use tooling (B) to loosen the plate assembly (4). Remove tooling (B). Remove plate assembly (4). Weight of the plate assembly is 120 lb. (54.43 kg). Measure the total thickness of the discs and