WASHER 2134222 - Caterpillar

1/4All 3500 Series And 6 Bore Vee EnginesReference: Service ManualThe 6V9433 Crankshaft Removal Group can be used to raise and turn the engine to permit easy removal of the crankshaft. This tool group has been designed primarily for removal of crankshafts from marine engines. However, it can be used in industrial applications where the crankshaft must be removed at the job site.
To decrease the possibility of injury in marine applications, this tool group must be used on vessels at rest and secured to a dock or pier.
Components Of The 6V9433 Crankshaft Removal Group
1. Rear Leg2. Front Leg3. Rear Mounting Bracket4. Front Mounting Bracket5. Front Upper Bridge6. Front Lower Bridge7. Rear Upper Bridge8. Rear Lower Bridge9. Reducer Assembly10. 6V9432 Bolt11. Cylinder Adapter12. Support Block13. Rear Extension14. Front Extension15. Leg16. Front Mounting Bracket17. Pin (not shown)Additional Hardware Needed
Hydraulic Pump
2 - 5P8739 or 5P9725 Hydraulic Cylinder2 - 5P159 Cap (if 5P9725 Hydraulic Cylinder is used)2 - 60210 Tee+*2 - 3B7722 Bushing*2 - 1P2375 Coupler Assembly (male)*4 - 1P2376 Coupler Assembly (female)*8 - 4S5414 Sleeve*2 - 8S7169 Coupling+*8 - 9S4123 Fitting*2 - 3B7722 Bushing ***Requirements are half if single-acting cylinders are used.+Not required if single acting cylinder and flow divider is used.**Required with flow divider.Optional -2V13-3-3S Flow Divider 20670 kPa maximum (3000 psi maximum)Manufactured by:Fluid Controls, Inc. 8341 Tyler Blvd.
Mentor, OH 44060
Phone: (800) 222-2600, Ext. 132
Telex: 98-5472
Installation Of Extensions And Modifications To Support Rails
(1) Disassemble the engine as necessary in preparation to remove the crankshaft; see Service Manual. Remove all parts above the cylinder heads that will make the engine top heavy and prevent the engine from being rotated 180°. Remove the bolts that fasten the cylinder block to the oil pan. (2) On 6 1/4 bore vee engines with short-channel supports, fasten extensions (1) to support rails with four S1973 Bolts and four 1B4332 Nuts at locations (B) and (C) on rear of support, and locations (A) and (C) on front of support. Fasten support blocks (2) to extensions (1) and against end of support with four S1595 Bolts and four 3B4508 Lockwashers. (3) On 6 1/4 bore vee engines with short angle support rails, drill six 10.7 mmØ (.422"Ø) holes at locations shown. Put 1/2"-13 threads in the six holes. Fasten extensions (3) to the outside of angle supports with six S1595 Bolts and six 3B4508 Lockwashers. Fasten support blocks (2) to extensions (3) and against end of support rail with four S1595 Bolts and four 3B4508 Lockwashers.
3500 WITH CHANNEL SUPPORT RAILS
6 1/4 BORE VEE WITH CHANNEL SUPPORT RAILS
3500 AND 6 1/4 BORE VEE WITH CHANNEL SUPPORT RAILS(4) On 3500 Series and 6 1/4 bore vee engines with channel support rails, drill 10.7 mmØ (.422"Ø) holes in support rails