WASHER-SPECIAL 2320793 - Caterpillar

40. Install the ring gear (48) for No. 2 clutch.41. Install the four disc assemblies and three plates of the No. 2 clutch beginning with a disc assembly.42. Install the No. 2 clutch springs (50) and reaction pins (49).43. Install two 7/16" -14NC forged eyebolts in the pressure plate (47). Fasten a hoist and put the pressure plate in position. Make sure springs (50) and pins (49) are correctly positioned in plate. Install and tighten the two bolts that keep the plate in position to 85 5 lb.ft. (11,8 0,7 mkg).44. Install the two seal rings for the balance piston in the No. 1 carrier housing (53).CAUTION: The seal rings are flat on inside diameter and around on outside diameter. Seal rings must be installed with flat side (painted side) in the direction of bottom of grooves in carrier.45. Install balance piston (51) on carrier (53).46. Put a multi-purpose grease on the twelve bearing assemblies of the planet gears. Put two bearing assemblies in each planet gear. Push the rollers in direction of outside of gears. Put the six planet gears (55) in carrier with a washer on each side of each gear.47. Install the six planet shafts and balls so that holes (52) in shafts are in alignment with notches (54) in carrier.48. Install the No. 2 sun gear (59) in carrier.49. Make cold the rear bearing race of the No. 1 carrier. Install the race (57) in bearing cage (58) so that hole in race is in alignment with hole in cage. Install the dowel that keeps race in position.50. Install the seal ring on bearing cage. Put oil on the seal ring.51. Put bearing cage (58) on carrier so three oil holes (56) are in alignment with O-ring seals (60) in carrier. Install bolts and locks.52. Turn over carrier, and install front bearing assembly (62) for No. 1 carrier. Install the retaining ring (61). Put oil on bearing assembly (62) and bearing race (57). 53. Install the seal ring in No. 1 clutch piston and in carrier. Put oil on seal rings. Put seal rings in the center of their grooves.