WASHER-SPRING 2795626 - Caterpillar

Illustration 58 g00647926
Detail A
Illustration 59 g00648260
View B-B
Use the following hardware to connect the 1P-6356 Plate (14) to the rear of the compressor.
One 8T-6466 Bolt (33)
One 8T-2561 Washer (26)
Use the following hardware to connect the 106-8704 Arc Suppressor (5) to the compressor.
One 3S-2093 Cable Strap (2)
One 9U-2277 Clip Assembly (4)
One 5P-4116 Washer (20)
One 8T-4189 Bolt (31)
Use one 9X-7378 O-Ring Seal (34) in order to connect the 114-5333 Pressure Switch (6) to the compressor.
Secure the pressure switch (6) with one 7K-1181 Cable Strap (3) .
Use the following hardware in order to connect the 130-5890 Air Conditioner Harness (7) to the compressor.
Three 3S-2093 Cable Straps (2)
One 4P-7581 Clip (18)
Two 9U-2277 Clip Assemblies (4)
Four 8T-4121 Hard Washers (27)
Two 8T-4133 Nuts (28)
Two 8T-4186 Bolts (30)
One 4P-7581 Clip (18)
One 3E-4056 Air Conditioner Fitting (17) Charge the System
Charge the air conditioner system. The correct charge is 2 kg (4.4 lb). Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the correct procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the correct tools.Installation of Cab Panels
Illustration 60 g00361017
Install the plastic cover (9) .
Illustration 61 g00361016
Install four bolts (7) and cover panel (8) .
Illustration 62 g00361015
Install two bolts (6) .
Illustration 63 g00361014
Install three bolts (5) .
Tighten two screws (3). Install the air filter cover (4) and the air filter.
Illustration 64 g00361013
Install the air filter (2) that is located on the left side of the cab.
Illustration 65 g00361012
Close the access door (1) .
Close the engine hood.
Install the seat. Refer to the appropriate Disassembly and Assembly, "Seat-Remove and Install".