2V7354 WASHER-THRUST Caterpillar parts
824C, 825C, 826C, 980C, 980F, D44B, D550B
Rating:
Alternative (cross code) number:
CA2V7354
2V-7354
2V7354
CA2V7354
2V-7354
2V7354
Weight: 0.30 pounds 0 kg.
ARTICULATED TRUCK, WHEEL LOADER,
Compatible equipment models: 2V7354:
Number on catalog scheme:
5
For full view, you need register
Information:
Illustration 1 g03676938
Schematic of the brake accumulator oil pressure sensor for brake application and alert indicatorThis diagnostic code is associated with the brake accumulator oil pressure sensor for brake application and alert indicator. The sensor is connected to one input of the Power Train ECM. The contact is open during proper operation.The FMI 04 means that the ECM has determined that the normally open circuit is grounded.Note: The following test procedure may create other diagnostic codes. Ignore these diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1612 FMI 04 is active before performing this procedure.Test Step 1. CHECK THE SENSOR
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the sensor.
Turn the key start switch and the disconnect switch to the ON position.Expected Result:The CID 1612 FMI 04 has been replaced by CID 1612 FMI 03.Results:
YES - The CID 1612 FMI 04 has been replaced by CID 1612 FMI 03. The machine harness and the ECM are correct. Proceed to Test Step 3.
NO - The CID 1612 FMI 04 is still active. Proceed to Test Step 2.Test Step 2. CHECK THE HARNESS
Turn the disconnect switch and the key start switch to the OFF position.
The machine harness remains disconnected from the sensor.
Disconnect the machine harness connector\s from the ECM.
Measure the resistance between contacts J2-50 (wire X779-GY) of the machine harness to all the contacts that are used in machine harness connectors for the ECM.Expected Result:Each resistance measurement is greater than 5 ohms.Results:
YES - Each resistance measurement is greater than 5 ohms. Proceed to Test Step 3
NO - One or more of the resistance measurements are less than 5 ohms. The harness has failed. The short is between J2-50 (wire X779-GY) and the circuit with the lowest resistance.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE OPERATION OF THE SENSOR
The machine harness remains disconnected from the sensor.
Measure the resistance between contact C and contact D of the harness connector for the sensor.
Measure the resistance between contact C and contact B of the harness connector for the sensor.Expected Result:The resistance from contact
Caterpillar parts catalog:
Parts washer Caterpillar catalog:
120B, 120G, 12E, 12G, 130G, 140, 140B, 140G, 14E, 14G, 16, 16G, 215, 215B, 215C, 215D, 225, 225D, 227, 229, 229D, 231D, 235, 235B, 235C, 245, 245B, 307, 312, 312B L, 315, 315B L, 317, 317B LN, 318B, 3...
120B, 12E, 140, 140B, 315B L, 317B LN, 916, 918F, 924F, 926, 926A, 928F, 936, 936F, 950B, 950B/950E, 950F, 950F II, 960F, 962G, 963, 963B, 963C, 963D, 966D, 966F, 966F II, 966M, 966M XE, 970F, 972M, 9...
163, 183B, 235, 615, 615C, 621, 621B, 621E, 621F, 621G, 621R, 623, 623B, 623E, 623F, 623G, 627B, 627E, 627F, 627G, 631C, 633, 633C, 633D, 641, 641B, 651, 651E, 657E, 657G, 769, 772, 773, 824, 824B, 82...
215, 215B, 215C, 824C, 824G II, 824H, 826G II, 826H, 834G, 834H, 836G, 836H, 836K, 988G, 988H, 988K
120G, 12G, 12H NA, 130G, 140G, 14E, 14G, 160G, 163, 16G, 183, 50, 561D, 594H, 621B, 627B, 633, 633D, 639D, 651, 777, 824C, 826C, 955C, 955H, 955K, 955L, 977D, 977K, 977L, 980C, 980F, 980F II, 983B, 98...
528, 561C, 561D, 5S, 639D, 6A, 6S, 825C, 931, 931B, 963, D5B, D5E, D6D, D6E, D6E SR, D6G, D6G SR, D6G2 LGP, D6G2 XL
950B, 963, 963B, 966D, 966K, 966M, 966M XE, 972K, 972M, 972M XE, 973, 980C, 980K, 980M, 982M, D8H
615, 615C, 623B, 825C, 977D, 977H, 977K
518, 528, 613, 613B, 613C, 777, 814, 815, 834B, 910, 916, 920, 926, 930, 930R, 936, 950, 950B, 950B/950E, 966C, 980B, 980C, 988B, CS-643, D250B, D25C, D25D, D300B, D300D, D30C, D350C, D35C, D35HP, D40...
16G, 16H, 16H NA, 508, 824, 824B, 824C, 825B, 826B, 826C, 834, 834B, 836, 980, 980B, 980C, 980F, 980G, 988, 988B, 988F, 988F II, D8N
14G, 14H, 14H NA, 16G, 16H, 16H NA, 824C, 824G, 824G II, 824H, 824K, 825C, 825G, 825G II, 825H, 825K, 826C, 826G, 826G II, 826H, 826K, 834B, 966G, 966G II, 966H, 966K, 966M, 966M XE, 972G, 972G II, 97...
824C, 980, 980B, 980C, 980F, R1700 II
824B, 824C, 825B, 825C, 826C, 980, 980B, 980C, 980F, 988, D44B, D550B, R1700 II
824C, 966G, 966H, 980C, 980F, R1700 II
824C, 980, 980B, 980C, 980F, R1700 II
8R4111
WASHER
5230, 834B, 988B
5230, 834B, 988B
69D, 769C, 769D, 770, 770G, 770G OEM, 771C, 771D, 772, 772G, 772G OEM, 834B, 834G, 834H, 836, 836G, 988B, 988F, 988F II, 988G, AD55, AD55B, AD60, R2900, R2900G, R3000H
768B, 769, 769C, 773B, 834B, 836, 988B
784B, 785, 785B, 789B, 994, 994D, AD45B, AD55
7E2455
WASHER-RETAINING
784B, 785B, 789B, 793, 793B, 994
784B, 785B, 789B, 793, 793B, 994
7V0448
WASHER
814B, 815B, 816B, 824C, 826C, 950B/950E, 950F, 966D, 966F, 980C, 980F, 980F II, 988B, 988F II, 992D, 994, 994D, R1700 II, R2900
814B, 815B, 816B, 824C, 826C, 950B/950E, 950F, 966D, 966F, 980C, 980F, 980F II, 988B, 988F II, 992D, 994, 994D, R1700 II, R2900
7V0447
WASHER
227, 814B, 815B, 816B, 824C, 826C, 950B/950E, 950F, 966D, 966F, 980C, 980F, 980F II, 988B, 988F II, 992D, 994, 994D, R1700 II, R2900
227, 814B, 815B, 816B, 824C, 826C, 950B/950E, 950F, 966D, 966F, 980C, 980F, 980F II, 988B, 988F II, 992D, 994, 994D, R1700 II, R2900
814B, 815B, 824C, 826C, 950B, 950B/950E, 950F, 950F II, 960F, 966D, 966F, 966F II, 970F, 980C, 980F, 980F II, 980G
980C, 980F, 980F II