WASHER 3895292 - Caterpillar

Illustration 1 g01970773
Schematic for the "Rack KO Detent" solenoid
This diagnostic code is associated with the "Rack KO Detent" solenoid. The FMI 05 diagnostic code means that the ECM has determined that an open in the circuit exists.The possible causes of this diagnostic code are listed below:
The signal circuit from the ECM to the "Rack KO Detent" solenoid is open.
The return circuit from the "Rack KO Detent" solenoid is open.
The internal windings for the detent coil have high impedance.
The internal windings for the detent coil are open.Note: The following test procedure may create other diagnostic codes. Clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0361 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The "Rack KO Detent" solenoid cannot be energized. This results in the loss of the kickout of the Rack. The control is unable to hold the lever in the detent position.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. Note: Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire H720-BU(Blue)) to contact 2 (wire R799-BR(Brown)).
Observe the status of the CID 0361 FMI 05 diagnostic code. Expected Result:The CID 0361 FMI 05 diagnostic code remains active.Results:
YES -