AVSPARE.COM
parts catalog

WASHER 4415646 - Caterpillar



4415646 WASHER Caterpillar parts WASHER
Rating:
61
Alternative (cross code) number:
CA4415646
441-5646
4415646
Caterpillar 4415646 WASHER
Weight: 0.33 pounds 0 kg.

Buy WASHER 4415646 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Which Generate This Code:The following conditions occur:445-1
The engine has been running for three minutes.
There are no active diagnostic codes for the auxiliary temperature sensor.
The temperature that is sensed by the auxiliary temperature sensor has exceeded the set point for four seconds.Note: The warning will be cancelled if the temperature falls 2 °C (4 °F) below the set point for two seconds.445-2
The engine has been running for three minutes.
There are no active diagnostic codes for the auxiliary temperature sensor.
The temperature that is sensed by the auxiliary temperature sensor has exceeded the set point for four seconds.Note: The derate will be cancelled if the temperature falls 2 °C (4 °F) below the set point for two seconds.445-3
The engine has been running for three minutes.
There are no active diagnostic codes for the auxiliary temperature sensor.
The temperature that is sensed by the auxiliary temperature sensor has exceeded the set point for four seconds.System Response:445-1The warning lamp will flash while the warning is active.The ECM will generate a E445-1 event code.The ECM will generate a SPN 1836-FMI 15 event code on the J1939 data link. The event code may be displayed on a receiving device on the J1939 data link.445-2The warning lamp will flash while the derate is active.The ECM will generate a E445-2 event code.Caterpillar Electronic Technician (ET) will display "Engine Derate" in the first "Engine Status" box on any Cat ET status screen.The ECM will generate a SPN 1836-FMI 16 event code on the J1939 data link. The event code may be displayed on a receiving device on the J1939 data link.445-3The warning lamp will flash.The ECM will generate a E445-3 event code.The ECM will generate a SPN 1836-FMI 00 event code on the J1939 data link. The event code may be displayed on a receiving device on the J1939 data link.445-1Engine operation is not affected.445-2The ECM will derate power by 25 percent. The power will be derated at one percent per second.445-3The engine will shut down.Test Step 1. Verify that the set points are valid for the application.Determine the events that caused the high temperature condition. Make corrections in order to prevent the high temperature from recurring.Results:
OK - STOP


Parts washer Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.