WASHER 4545227 - Caterpillar

Select Lane - Press to de-select the current lane. Press and hold to open the "Select Lane" dialog.Landfill compactor softkey icons
Decrement Layer - Press to decrement the current layer.
Increment Layer - Press to increment the current layer. Press and hold to open the "Mapping/Recording" dialog.Four Drum Landfill Compactor Softkey Icons
Drum: Left - Focus is on the left side of the left drum. Press to change focus to the right side off the right drum.
Drum: Right - Focus is on the right side of the right drum. Press to change focus to the left side off the left drum.
Offset - Press to open the "Offsets" dialog. Then, press <value> Offset to switch between horizontal and vertical.Mapping/Recording Softkey Icons
Reset Map - Press to open the "Reset Map" dialog. By default, this softkey is only displayed in Manager Mode.
Reset Thick Lift - Press to reset, or clear, any thick lift mapping that would occur.
Mapping: Auto - Map data is recorded when the machine is considered to be working. Press to change map recording to the On mode.
Mapping: On - Map data is recording continuously. Press to stop recording map data.
Mapping: Off - Map data is not recording. Press to change map recording to the Auto mode.
Record Point - Record a point, when point recording is active.
In-Field Report - Press to open the "In-Field Reporting" dialog.For additional Cat Compaction Control monitor information, refer to Operation and Maintenance Manual M0074064, "Cat Compaction Control for Landfill Compactors".Warning Categories
The Caterpillar Monitoring System notifies the operator of an immediate problem with a machine system or an impending problem with a machine system. The Caterpillar Monitoring System provides four warning categories. The categories are based on the severity of the problem. The categories dictate the required response of the operator.
Table 3
OPERATION
Warning Category Warning Indications (1) Required Action Possible Result (2)
Flashing Indicator Flashing Action Lamp Sounding of the Action Alarm
1 X No immediate action is required. The system needs attention soon. No harm or damage
2 X X Change machine operation or perform maintenance to the system. Severe damage to components
2-S X X X (3) Immediately change the machine operation. Severe damage to components
3 X X X (4) Immediately perform a safe engine shutdown. Injury to the operator or severe damage to components
(1) The warning indicators that are active are marked with an "X".
(2) These are possible results if no action is taken.
(3) The alarm is on continuously.
(4) The alarm is on intermittently.