WASHER 5C4314 - Caterpillar

8. Remove adapter (7) and the rack from the fuel injection pump housing (Woodward Governor only). Remove the rack from the fuel injection pump housing (hydramechanical governor only).9. Bend tabs of lock (5) away from bolts (4). Remove bolts (4) and guide (6) from the fuel injection pump housing (Woodward governor only). 10. Remove adapter (7) and spring (8) from rack (9) (Woodward Governor only). 11. Remove lifters (10) from the fuel injection pump housing. Keep lifters together with identification as to their location in the pump housing. 12. Bend lock (12) away from bolts (11). Remove bolts (11), locks (12), the sleeves and gear (13) from the camshaft. 13. Remove pin (16) and spring (14) from gear (13).14. Remove pin (17) and yoke (15) from spring (14). 15. Remove plate assembly (18) and the gasket from the fuel injection pump housing. 16. If necessary, remove bushing (19) from the plate assembly. 17. Remove bolts (21) plate (23) and spacer (22) that hold camshaft (20) in the fuel injection pump housing.18. Remove camshaft (20) from the fuel injection pump housing. 19. If necessary use tool group (D) and remove the camshaft bearing from the automatic timing advance end of the fuel injection pump housing.20. If necessary, remove rack bearing (24) from the automatic timing advance end of the fuel injection pump housing. 21. If necessary remove rack bearing (25) and dowels (26) from the governor drive housing end of the fuel injection pump housing.22. If necessary, use tool group (D) and remove camshaft bearing (27) from the governor drive housing end of the fuel injection pump housing and the center bearing in the fuel injection pump housing.Assemble Fuel Injection Pump Housing
1. Use tooling (A) to install the camshaft bearings in fuel injection pump housing (1). Install the camshaft bearings so that the bearing joints are 15° from the vertical centerline of the bores. Install the front and rear camshaft bearings even with the outside surfaces of fuel injection pump housing (1). Install the center camshaft bearing to a distance of 122.2 0.5 mm (4.81 .02 in.) from rear face (X). After assembly the inside diameter of the camshaft bearings must be 53.988 0.038 mm (2.125 .01 in.). 2. Use tooling (B) and install the rack bearing even with the outside surface of fuel injection pump housing (1). Make sure the tab in the rack bearing is installed toward the inside and within .05 mm (.003 in.) of the vertical center line of the bearing bore. After assembly the inside diameter of the rack bearing must be 12.758 0.046 mm (.502 .002 in.). 3. Use tool group (C) to install the rear rack bearing. Install the rack bearing to a depth of 7.16 0.13 mm (.282 .005 in.) below the outside surface. The small holes in the rear rack bearing must be installed parallel to the vertical centerline of the bearing bore. After assembly the inside diameter of the bearing