WASHER 5F9140 - Caterpillar

Start By:
Remove the piston motor. Note: Mark all components for correct installation. Before you disassemble the unit, cover the ports and clean the outside of the unit in order to keep the components clean.
Illustration 1 g01064963
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove bolts (1) and head (2).
Illustration 2 g01064965
Remove O-ring seal (3) and plate (4). Install Tooling (C) into the barrel. Note: Tooling (C) will keep the rotating group together while the rotating group is being removed from the pump housing.
Illustration 3 g01064967
Remove retaining ring (5).
Illustration 4 g01064968
Remove cover (6).
Illustration 5 g01064969
Remove seal (7) from cover (6).
Illustration 6 g01064970
Remove O-ring seal (8) and shims (9).
Illustration 7 g03431108
Install Tooling (A) in order to remove rotating group (10) from housing (11).
Illustration 8 g00835428
Remove barrel (12) from the pistons.
Illustration 9 g00835431
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove spring (13) and shim (14) from barrel (12). Remove Tooling (C).
Illustration 10 g00835572
Remove screws (15) from the shaft. Remove plate (16) and the pistons from the shaft.
Illustration 11 g00835632
Remove pin (17) and pistons (18) from plate (16). Note: The piston rings are not serviceable.
Illustration 12 g01123006
Remove retaining ring (19) from shaft (20).
Illustration 13 g03431127
Use a suitable press and Tooling (B) in order to remove bearings (21) from shaft (20). The bearings are serviced only as a kit in order to maintain proper bearing preload.