WASHER-ON 5K0906 BOLT 5P4116 - Caterpillar

Illustration 1 g01211086
EMCP 3 Control System Panel (1) Display Screen (2) Yellow Warning Lamp (3) Red Shutdown Lamp (4) Alarm Acknowledge/Silence key (5) Lamp Test key (6) Stop key (7) Auto key (8) Run key (9) Escape key (10) Enter key (11) Right key (12) Down key (13) Up key (14) Left key (15) Engine Overview key (16) AC Overview keyGeneral Information
The main component of the "Electronic Modular Control Panel 3" (EMCP 3) is the "Electronic Control Module" (ECM). This section discusses the display, keys, and indicators on the control system panel of the ECM. The EMCP 3 panel is used for monitoring and controlling many of the generator set functions. Some of the functions include:
Sending start and stop signals to the engine
Providing visual and audible indications when warning or shutdown events occur
Displaying Engine information and AC generator set information
Displaying Suspect Parameter Number (SPN) and Failure Mode Identifier (FMI) information for events
Programming set points for the standard EMCP 3 (The set points for optional modules are set with the use of Cat ET.)ECM Front Panel Components
The following components can be found on the front panel of the ECM:
Information Display
Alarm Indicators
Alarm Acknowledge/Silence Key
Function Keys
Navigation Keys
System Overview KeysInformation Display
(1) Display Screen - Information from the EMCP 3 is displayed on the Display Screen. This screen is used for the following programming and display functions.
Displaying AC parameter information of the generator set
Displaying Engine parameter information of the generator set
Programming set points for the generator
Displaying Engine Event information
Displaying Event codes from other modules
Programming the display preferences of the EMCP 3
Changing password levels of the EMCP 3Alarm Indicators
(2) Yellow Warning Lamp - A solidly illuminated Yellow Warning Lamp indicates that there are acknowledged warnings that are still present. A flashing Yellow Warning Lamp indicates that there are unacknowledged warnings that are still present. In order to verify the warnings, press the Alarm Acknowledge/Silence key (4) . If there are no longer any active warnings, then the lamp will turn off. If active warnings still exist, then the lamp will change from flashing yellow to solid yellow. (3) Red Shutdown Lamp - An illuminated Red Shutdown Lamp indicates that there are acknowledged shutdown events that are still active. A flashing Red Shutdown Lamp indicates that there are unacknowledged active shutdown events. In order to verify the shutdown events, press the Alarm Acknowledge/Silence key (4) . If there are no longer any active shutdown events, then the lamp will turn off. If active shutdown events still exist, then the lamp will change from flashing red to solid red.Note: Any condition that has caused a shutdown event must be manually reset.ReferenceSystems Operation, "Event Resetting"Alarm Acknowledge/Silence Key
(4) Alarm Acknowledge/Silence - Pressing the Alarm Acknowledge/Silence key causes the horn relay output to turn off, which silences the alarm. When the alarm acknowledge key is pressed, a "global acknowledge" command is transmitted on the CAN data link. Other modules may be configured to respond to the "global acknowledge" signal. When the horn relay sounds, one or both of