WASHER-BEARING LOCK 6V0916 - Caterpillar

Certain programmable parameters must be entered in order for the electronic control system to operate properly. Other programmable parameters are adjusted according to the customer's preferences for the installation.Caterpillar Electronic Service Tools are designed to help the service technician perform the following functions:
Obtain data.
Diagnose problems.
Read parameters.
Program parameters.
Calibrate sensors.Connecting the Caterpillar Electronic Technician (Cat ET) to the Electronic Control Module (ECM)
Refer to Troubleshooting , "Electronic Service Tools" for a list of required tools and instructions.Recommendations for Programming the System Configuration Parameters
The values of the parameters can be viewed on the "Configuration" screen of Cat ET.Programmable parameters enable the engine to be configured to meet the requirements of the application. The system configuration parameters must be programmed when the application is installed. Perform this programming before the initial engine start-up.Data from a gas analysis is required to determine the correct settings for the air/fuel ratio control. The data must be entered into Caterpillar Software , "Gas Engine Rating Pro (GERP)". Incorrect programming of parameters may lead to complaints about performance and/or to engine damage.If an ECM is replaced, the appropriate parameters must be copied from the original ECM. This action can be done with the "Copy Configuration" feature of Cat ET. Alternatively, the settings can be recorded on paper and then programmed into the new module.
Changing the parameters during engine operation can cause the engine to operate erratically. This action can cause engine damage.Only change the settings of the parameters when the engine is STOPPED.
Note: Refer to Systems Operation, "Electronic Control System Parameters (Configuration Parameters)" for further information.Changing the Settings of the Monitoring System
To change the settings of the parameters, use Cat ET and select the "Service/Monitoring System" screen.Use care when you program the trip points and the delay times. Ensure that the response of the ECM is correct for the application. The monitoring system will accept any settings within the ranges.
Changing the parameters during engine operation can cause the engine to operate erratically. This action can cause engine damage.Only change the settings of the parameters when the engine is STOPPED.
Note: Refer to Systems Operation, "Engine Monitoring System" for further information.