WASHER 7S2962 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every 50 Service Hours
Zinc Rods - Inspect/Replace
Every Week
Battery Charger - Check
Every 250 Service Hours or 6 Months
Air Compressor - Check
Alternator - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 5700 L (1500 US gal) of Fuel or 400 Service Hours or 1 Year
Aftercooler Condensate Drain Valve - Inspect/Clean
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Engine Valve Lash - Check
Every 500 Service Hours
Air Shutoff - Test
Fumes Disposal Filter Element - Replace
Every 2000 Service Hours or 1 Year
Aftercooler Core - Clean/Test
Aftercooler Core - Inspect
Engine Valve Lash - Check
Every Year
Coolant Sample (Level 2) - Obtain
Every 132 475 L (35 000 US gal) of Fuel or 5000 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 4000 Service Hours or 2 Years
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Speed Sensor - Clean/Inspect
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add