WASHER-HARD 7X0531 - Caterpillar

Reference: Special Instruction Form SEHS7807; Special Instruction Form SEHS7931; Special Instruction Form SEHS8135; Special Instruction Form SEHS8029 The 8T5200 Signal Generator/Counter Group includes the 8T5201 Signal Generator with the necessary cables and adapter needed to make the tool operational. The 8T5201 Signal Generator is a small, hand held, square wave generator that can be used to simulate speed for troubleshooting transmission electronic control units. (A magnetic pickup will not be needed.) An 8 Volt square wave "OUTPUT" connection is provided for this purpose.The 8T5201 Signal Generator can also be used as a calibrator for most electronic diagnostic tools that now use the 5P9698 Calibrator. A 3 Volt square wave "CAL OUT" connection is provided for this purpose. The frequency (Hz) range is approximately 3-7000 Hz, infinitely variable, by turning the "Hz" adjustment knob. In addition, the 8T5201 Signal Generator can be used as a frequency (Hz) counter when the input is a pulsating DC or AC signal of .1 to 50 Volts maximum.8T5200 Signal Generator/Counter Group Components
1 6V2198 Extension Cable.2 6V3072 Case.3 Instruction Form SEHS8579.4 6V6045 Accessories Case.5 Form SEHS8009 Accessories Case Decal.6 8T5112 Signal Input Cable.7 8T5197 Calibrator Cable and Adapters.8 Adapter [Part of Cable (6)].9 8T5198 Transmission Adapter Cable.10 Adapter [Part of Cable (6)].11 8T5267 Foam Block.12 8T5201 Signal Generator/Counter. Decal SEES5688 (not shown) Operation Instructions on Rear of Signal Generator/Counter. Decal SEES5689 (not shown) Carrying Case Label.Additional Service Parts for use with the 8T5201 Signal Generator/Counter are:8T5199 Front Panel Membrane Switch Assembly.8T0844 Front Plastic Cover.6V3110 Back Plastic Cover.8T1005 LCD Display.8T0887 Display Connector Assembly.An optional accessory that is available for use with the 8T5200 Signal Generator/Counter Group is the 6V6152 Adapter. The 6V6152 Adapter is used with the 8T5200 Signal Generator/Counter Group when it is necessary to check a 6V6113 Amplifier. See the information in this instruction.Another optional accessory that is available for use with the 8T5200 Signal Generator/Counter Group is the 9W6370 Harness. The 9W6370 Harness is used with the signal generator/counter group to make a functional check and/or calibration check for two and three element electronic speed switches.Features Of The 8T5200 Signal Generator/Counter Group
Hz DISPLAY:Hz (Hertz or frequency) is directly displayed on a liquid crystal digital (LCD) display in numbers that are 12.7 mm (.5") high. The display is visible in direct sunlight and also in low-light conditions.OUTPUT/OFF/ON:When it is necessary to disconnect the output signal, use the OUTPUT/OFF switch. This permits the internal oscillator to continue running but output will be "0". This helps to maintain a steady frequency when the signal is again connected with the OUTPUT/ON switch. The LCD OUTPUT/OFF indicating arrow is visible when the output signal is disconnected and the readout will be blank.FREQUENCY RANGES HI/LO:The LO range switch permits easy selection of any frequency from 3-300 Hz. The HI range switch permits easy selection of any frequency from 40-7000 Hz. The specific range will be indicated with an arrow on the readout. If the maximum frequency in each range becomes lower than normal, it is an indication that