WASHER-CRANKSHAFT PULLEY 8N0794 - Caterpillar

Start the Engine
The following table lists the limits for temperature range:
Table 1
Package Details Starting Temperature Operating Temperature Range
1 10W30 engine −9 °C (15.8 °F) 0 °C (32 °F) to 35 °C (95 °F)
10W hydraulics
30W Transmission
2 10W30 engine −9 °C (15.8 °F) to −18 °C (−0.4 °F) −18 °C (−0.4 °F) to 10 °C (50 °F)
10W hydraulics
10W Transmission
3 0W40 engine −18 °C (−0.4 °F) to −40 °C (−40 °F) −40 °C (−40 °F) to −10 °C (14 °F)
0W hydraulics
0W Transmission
Move the transmission direction control switch into NEUTRAL.
Lift the steering column release lever and move the steering column to the desired position. Push the steering column release lever to the lock position.
Engage the parking brake by pushing the top of the parking brake switch.
Ensure that the implement control levers are in the HOLD position.
Before the engine is started, check for the presence of bystanders or maintenance personnel. Ensure that all personnel are clear of the machine. Briefly sound the forward horn before you start the engine.
Turn the engine start switch to the ON position. Pause for the system to perform the self test. Note: In applications for cold weather, pause until the indicator lamp for the starting aid turns off.
Do not push down on the throttle pedal. Turn the engine start switch key to engage the starter. Release the key when the engine starts.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again.Turbocharger damage can result, if the engine is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.
Warm up the Engine and Machine
Keep engine speed low until the engine oil pressure indicator light goes out. If the engine oil pressure indicator light does not go out within 10 seconds, stop the engine. Investigate the cause of the problem before you start the engine again.Note: The hydraulic lockout must be in the Unlocked position before the hydraulic controls will function.
Allow the engine to warm up at low idle for at least 5 minutes. Engage the work tool controls and disengage the work tool controls. The warm-up of the hydraulic components will be faster.
Look at the indicators and the gauges frequently during operation. The hydraulic oil will warm up faster by stalling one function and actuating a second function for short periods of 10 seconds or less.Note: The hydraulic control valve may become overheated if the bucket is operated continuously under relief conditions.Cycle all controls in order to allow warm hydraulic oil to circulate through all hydraulic cylinders and through all hydraulic lines.When you idle the machine for warm-up, heed the following recommendations:
If the temperature is greater than 0° C (32° F), warm up the engine for approximately 15 minutes.
If the temperature is less than 0° C (32° F), warm up the engine for approximately 30 minutes.
If the temperature is less than − 18°C (0°F) or if hydraulic functions are sluggish, additional time may be required.