WASHER 8N2637 - Caterpillar

Illustration 1 g02587796
Left side view
Illustration 2 g01581933
Rear view
Table 1
Specification for 296-9886 Auxiliary Sea Water Pump Gp    
Item     Qty     Part     Specification Description    
1     3     8T-2226 Screw     Torque to
11 3 N m (95 27 lb in).    
2     1     5S-7383 Bolt     Use the following procedure to tighten the bolt:
1. Torque to
55 7 N m (41 5 lb ft).
2. Tap the bolt lightly with a hammer.
3. Again, torque to
55 7 N m (41 5 lb ft).    
3     As required, use the following shims on each side of the impeller to obtain an axial clearance of
0.35 to 0.45 mm (0.014 to 0.018 inch).    
1 100-3061 Shim     Thickness is
0.127 mm (0.0050 inch).    
1 100-3062 Shim     Thickness is
0.254 mm (0.0100 inch).    
1 100-3063 Shim     Thickness is
0.305 mm (0.0120 inch).    
1 100-3064 Shim     Thickness is
0.381 mm (0.0150 inch).    
4     1     100-3081 Locknut     Torque to
40 5 N m (30 4 lb ft).    
5     1     104-6641 Bearing Locknut     Torque to
40 5 N m (30 4 lb ft).    
6     -     -     Fill the bearing cavity with clean grease.    
7     1     109-5030 Impeller     Apply blue Loctite 242 to the threads.    
8     1     109-5031 Impeller     Apply blue Loctite 242 to the threads.    
9     2     186-0128 O-Ring Seal     Lubricate the bore lightly with the rubber lubricant that is being sealed.    
A     1     297-5188 Elbow     Orient within 22.5 5.0 degrees from the horizontal position.    
C     1     153-9075 Manifold     Orient within 22.5 5.0 degrees from the horizontal position.    
D     2     3N-8220 Clamp As     Orient within 11 5 degrees from the horizontal position.