WASHER 9P8218 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     3    Start By:
Remove the torque converter. Refer to Disassembly and Assembly , "Torque Converter - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all harness assemblies, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01357604
Disconnect harness assemblies (2) and (3) from torque converter (1) and remove all mounting hardware.
Illustration 2 g01357551
Disconnect harness assembly (4) and remove all mounting hardware.
Illustration 3 g01229803
Remove bolts (5) and cover (6) .
Illustration 4 g01229809
Remove magnetic filter (7) and screen (8) .
Illustration 5 g01229810
Remove bolts (9) and oil pan (10) .
Illustration 6 g01459190
Note: Bolt (12A) will be removed later.
Remove tube assemblies (15) and (16) . Disconnect harness assembly (13) and remove oil level sensor (14) . Remove bolts (18) and housing (17) . Remove bolts (11) and pump (12) .
If equipped, remove the rear PTO shaft.
Illustration 7 g01459370
Attach a suitable lifting device to Tooling (A) on torque converter housing (19) . The weight of torque converter housing (19) is approximately 79 kg (175 lb). Remove bolt (12A) from Step 6. Remove bolts (20) and torque converter housing (19) from transmission (21) .
Illustration 8 g01459374
Remove lip seal (22) from torque converter housing (19) .