WASHER 9W6584 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 487-3130 Engine Turning Tool 1 Start By:
Remove oil pan.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g06069666
Install Tooling (A). Use Tooling (A) to turn the crankshaft until the connecting rod bearing caps are accessible.
Illustration 2 g06069704
Mark connecting rod (3) and connecting rod cap (1) for identification and location.Note: This engine has fractured connecting rods. Fractured connecting rods must be handled with care. Use a soft faced hammer to tap the connecting rod cap, if necessary.Note: Do not place the fractured faces of the connecting rod cap on any surface. The connecting rod cap must be laid flat on the side to prevent damage to the fractured faces of the connecting rod cap.
Remove connecting rod cap bolts (2) and connecting rod cap (1) from connecting rod (3).
Illustration 3 g01139029
Remove the lower half of connecting rod bearing (5) from connecting rod cap (1).
Push connecting rod (3) away from the crankshaft. Remove the upper half of connecting rod bearing (4) from connecting rod (3).Note: Do not damage the fractured faces of the connecting rod. Place a suitable protective cap on the ends of the connecting rod to prevent damage to the fractured faces of the connecting rod.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The joint between the connecting rod and the connecting rod cap is produced by fracturing. The connecting rod assembly must be handled with care in order to avoid damage to the mating surfaces. The connecting rod assembly must be replaced if any damage occurs to the mating surfaces. New connecting rod assemblies come with the connecting rod caps bolted on the connecting rod.Use only a soft faced hammer to tap the connecting rod cap when separating the connecting rod cap from the connecting rod.Failure to use a soft faced hammer may result in damage to the fractured surfaces of the connecting rod assembly.
Use Tooling (A) to turn the crankshaft until the connecting rod and bearing cap mating surfaces are accessible.
Illustration 4 g01139029Note: Install the connecting rod bearings dry when clearance checks are performed. Apply clean engine oil to the connecting rod bearings for final assembly.
Remove the protective caps from the end of the connecting rod and install the upper half of connecting rod bearing (4). Ensure that the bearing tab engages with the slot in connecting rod (3).
Pull the piston and connecting rod assembly onto the crankshaft.
Install the lower half of connecting rod bearing (5) into connecting rod cap (1). Ensure that the bearing tab engages with the slot in connecting rod cap (1).Note: Do not place the fractured faces of the connecting rod cap on any surface. The connecting rod cap must be laid flat on the side to prevent damage to the fractured faces of the connecting rod cap.
Install connecting rod cap (1) and connecting rod cap bolts (2). Lubricate threads of connecting rod bolts (2) with clean engine oil.
Check the bearing clearance. Refer to