WATER PUMP GROUP 2M7894 - Caterpillar

The connection of any electrical equipment and the disconnection of any electrical equipment may cause an explosion hazard which may result in injury or death. Do not connect any electrical equipment or disconnect any electrical equipment in an explosive atmosphere.
Operating the engine with a Personality Module not designed for that engine will damage the engine. Be sure the Personality Module is correct for your engine.
Note: Factory passwords are calculated on a computer system that is only available to Caterpillar dealers.Factory passwords are required to perform each of the following functions:
Program a new Electronic Control Module (ECM).
When an ECM is replaced, the system configuration parameters must be programmed into the new ECM. A new ECM will allow these parameters to be programmed once without factory passwords. After the initial programming, some parameters are protected by factory passwords.
Clear event codes.
Most event codes require the use of factory passwords to clear the code once the code has been logged. Clear these codes only when you are certain that the problem has been corrected.
Unlock parameters.
If a parameter has been locked out, factory passwords are required to unlock the parameter. Refer to Troubleshooting, "System Configuration Parameters" for additional information.Since factory passwords contain alphabetic characters, the Caterpillar Electronic Technician (ET) must be used to perform these functions. In order to obtain factory passwords, proceed as if you already have the password. If factory passwords are needed, Cat ET will request the factory passwords and Cat ET will display the information that is required to obtain the passwords. For the worksheet that is used for acquiring factory passwords, refer to Troubleshooting, "Factory Passwords Worksheet".