WATER PUMP 5P8973 - Caterpillar

Engine: All 3600 All C280 All G3600Introduction
Do not perform any procedure in this publication or order any parts until you understand the information that is contained in this publication.This Special Instruction explains the operation of the Intellifast Ultrasonic IHS Reader. The Intelifast IHS Ultrasonic Reader is used to measure the load on the 369-7181 Bolt As connecting rod bolt.
Illustration 1 g02488678
"LoadProbe 3000B Intellifast Reader"The memory stick, that can be found in one of the pouches of the carrying case lid, contains the complete users manual. The users manual documents the operation of the device in more detail. The users manual also explains the process of saving the files to text and then saving the files to a memory stick. The files can then be downloaded to an Excel spreadsheet for review and storage.Quick Start Procedure For Using the Ultrasonic Reader
The "LoadProbe 3000B Intellifast Reader" uses a Windows XP-based program. A Microsoft compatible mouse can be plugged into one of the USB ports. Using the mouse makes navigation through the program quicker and easier.Note: Always use the same sequence for recording the engine bolt loads. Using the same sequence will simplify finding a particular bolt for inspection at a later date. A typical sequence would be to start with cylinder (1) and proceed to the last cylinder.
Charge the batteries in the battery charger before continuing with this procedure.
Plug the charged batteries into the left side of the reader.Note: The batteries can be changed while using the reader. The reader will operate on a single battery.Note: The reader can also be powered using the AC power supply. The power supply operates on 120 VAC at 60 Hz or 240 VAC at 50 Hz.
Illustration 2 g02745059
(1) Ultrasonic sensor connector (2) Temperature sensor connector (3) Communication cable connector (4) Bar code reader connector
Plug the four cables into the right side of the reader.
The ultrasonic sensor signal cable (1) plugs into the front receptacle that is labeled "Probe". Ensure that the red dot on the connector is on top and aligns with the dot on the reader.
The temperature sensor (2) plugs into the next receptacle that is labeled "PT100".
The communication cable (3) plugs into the 9-pin serial connection.
The bar code reader (5) plugs into one of the USB ports on the right side of the reader.
Illustration 3 g02745060
(5) Ultrasonic sensor
Uncoil the cables and be sure that ultrasonic sensor (5) is exposed to free air and not in contact with any metal.
Do not unplug any of the cables while the unit is powered up. The ultrasonic sensor could be damaged. Turn the unit OFF before unplugging any cables.
Turn on the reader by pressing the "Power" button. Wait for Win XP to load and then start the software.The "Store STOF" box should be highlighted. If the box is not highlighted, use the arrow or the tab keys to toggle to the "Store STOF" box. The box will then be highlighted.
Illustration 4 g02502217
Information box
Press the "Enter" button. The "Enter" button is the lower button on the right side of