WEAR TIP 2929410 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     352-5891     Strap     2    
D     -     Loctite 771     1    
Illustration 1 g01984235
Typical Example
Illustration 2 g01984247
Typical Example
Put identification Marks (B) on both sides of clamp assemblies (1) for installation purposes.
Put identification Mark (C) on the diesel particulate filter (3) for installation purposes. Identification Mark (C) is showing the flow of exhaust gases through the diesel particulate filter.
Loosen clamp assemblies (1) and reposition the clamp assemblies toward the center of diesel particulate filter (3) .
Position Tooling (A) on the diesel particulate filter (3) and disconnect strap (2) .Note: Do not allow any objects to contact the internal element of the diesel particulate filter . Do not bump or shake the filter assembly.
Use Tooling (A) in order to remove diesel particulate filter (3) . The weight of diesel particulate filter (3) is approximately 15 kg (33 lb). Discard both clamp assemblies (1) .Installation Procedure
Install diesel particulate filter (3) in the reverse order of removal.
Illustration 3 g02165433
Apply Tooling (D) to the threads of strap (2) to Dimension (X) . Dimension (X) is 25 mm (1.0 inch) above the trunnion. Tighten strap (2) to a torque of 16.5 1.5 N m (146 13 lb in).
Install new clamp assemblies (1) . Torque the new clamp assemblies (1) to a torque of 42 2.5 N m (31 1.8 lb ft). Do not use power tools in order to tighten clamp assemblies (1) ., End By: Reset the engine ash model. Refer to Special InstructionREHS5026.