WELDMENT 8C1744 - Caterpillar

Removal Procedure
Start By:
Remove the electronic control module. Refer to Disassembly and Assembly, "Electronic Control Module - Remove and Install".
Illustration 1 g01254468
Typical example
Remove plastic tube assembly (3) and assembly (4) from clips (5).
Cut the cable strap and position the engine wiring harness away from mounting bracket (2).
Remove bolts (1) and remove mounting bracket (2) from the cylinder head.
If necessary, remove clips (5) from mounting bracket (2). Installation Procedure
Ensure that the mounting bracket for the electronic control module is clean and free from damage. If necessary, replace the mounting bracket.
Illustration 2 g01254468
Typical example
If necessary, install clips (5) to mounting bracket (2).
Position mounting bracket (2) against the cylinder head. Install bolts (1). Tighten the bolts to a torque of 22 N m (16 lb ft).
Position the engine wiring harness against mounting bracket (2). Secure the engine wiring harness with a new cable strap.
Install plastic tube assembly (3) and assembly (4) to clips (5). End By:
Install the electronic control module. Refer to Disassembly and Assembly, "Electronic Control Module - Remove and Install".