WHEEL & FINAL DRIVE GP 1223742 - Caterpillar

Illustration 1 g00868704
A junction box is located to the right of the operator control panel.Push in the reset button. This will reset the circuit breakers. If the system is operating properly, the button will stay depressed. If the button does not stay depressed, you should check the electrical circuits.Engine Start Relay (1) - 10 ampAlternator Circuit Breaker (2) - 80 ampMain Circuit Breaker (3) - 80 ampRoading Lights, Work Lights, Flasher, Turn Signals, and Hazard Lights (4) - 15 ampLight Switch, Brake Pressure Switch, and Tail Lights (5) - 10 amp
Illustration 2 g00868730
Note: Throttle Controller, Back Up Alarm, Horns, Rotor Brake Release Solenoid, Rotor Service Switch, Horn Switch, Rotor Door Switch, Propel Axle Lock Switch, Propel Axle Lock Solenoid, Rotor Hood Tilt Switch, Hourmeter, Electric Hydraulic Pump motor Relay, Rear Door Raise and Lower. Solenoids (6) 15 amp.Cab (7) - 15 ampCab (8) - 15 ampCab (9) - 15 ampCab and Air Conditioning Compressor (10) - 20 ampNote: ECM, Steer Mode Sensor, Position Sensor for the wheels,Rear Steer Switch, Propel Sensor, Engine Speed Sensor, Parking Brake, Rotor Depth Sensor,Lift Lock Switch, Foot Brake Pressure, Rotor Solenoid Switch, Rotor Depth Mode, Rotor Control, Rotor Depth Indicator, Fuel Solenoid, Propel Pump Solenoid, Parking Brake Solenoid, Rotor Control Solenoid, Steering Solenoid, Rotor Brake Solenoid.Rotor Speed Sensor Switch (11) - 15 ampAdditive System (12) - 15 ampRear Wheel Drive, and the Pump Motor for the Electro-Hydraulic Rotor Brake Service (13) - 20 ampCaterpillar Monitoring System Control, Caterpillar Monitoring System Master Lamp, Mode Selector Switch, Fuel Level Sender, Engine Coolant Temperature Sensor, Transmission Oil Temperature Sensor, Hydraulic Oil Temperature Sensor, Engine Oil Pressure Sensor, Left Turn Signal, Right Turn Signal, Caterpillar Monitoring System Alarm, Four-Way Hazard Switch, Diagnostic Switch, Transmission Filter Switch, and Differential Lock (14) - 10 ampRotary Beacon, Switch for the Rotary Beacon, Service Light, Release for the Auxiliary Brake, and Propel and Full Enable (15) - 15 ampHigh Idle Relay (16) - 30 amp