WHEEL GP 1C9009 - Caterpillar

Auxiliary Tool Control
The purpose of this feature is to provide the operator a means to control the hydraulic oil flow to a tool attached to the front of the skid steer loader. Examples of commonly used tools are multi-purpose buckets, large brooms, grapple buckets, cold planers, and so on.Bucket Tilt Control
Allows the ECM to control rackback and dump movement of the loader bucket based on operator input through the x-axis movement of the right control joystick.Lift Arm Raise/Lower Control
Allows the ECM to control the up and down movement of the loader lift arms based on operator input through the implement control joysticks.Continuous Flow Control
This feature provides the operator a means to operate the auxiliary hydraulic circuit continuously without having to actuate the proportional or on/off input. This feature will be used with tools such as a broom or an auger.Interlock Override Control
The interlock override feature is used with the continuous flow function so the operator can set hydraulic flow to the work tool and then exit the machine to enable the use of tools such as a back hoe attachment or other remote operated implements that have controls external to the cab.Once the continuous flow feature has been set, pressing and releasing the interlock override switch will activate the interlock override. This action will allow the operator to exit the machine and leave the hydraulic system activated. To discontinue use of the continuous flow feature, the operator must actuate the auxiliary hydraulic input device. Another way is to press and release the continuous flow switch again.Joystick Pattern Changer
The joystick pattern changer feature allows the operator to select between pattern "1 " (Cat) joystick control and pattern "2" (Alternate) joystick control.The joystick pattern can be selected through Cat ET. After a pattern is selected, one of the two pattern indicator lamps on the instrument cluster will be illuminated to indicate to the operator what mode the machine controls are in. If a joystick pattern has not been selected, the pattern changer indicator will flash. The parking brake will not release until a pattern has been selected.If pattern changer is not installed, the machine will default to pattern "1" mapping and no pattern indicator lamp will be illuminated.Ride Control
Allows the ECM to smooth the ride of the machine by using the combination of the weight of the implement (lift arms and bucket) and an accumulator to act as a shock absorber.Dual Direction Self Level
The Self Level feature allows the ECM to adjust flow to the tilt cylinders during a lift or lower command to maintain the starting angle of the work tool relative to ground.The Return-to-Dig function allows the operator to set a predefined bucket angle that the ECM can be triggered to return the lift arms to fully lowered and the bucket to be at that angle.Work Tool Positioner mode allows the operator to set a predefined bucket angle. The ECM is then triggered to return bucket to be at that angle. The Work Tool does this action without